The i310s current probe is based on hall effect technology for use in measurement of both DC and AC current
Safety BNC connector supplied with safety 4 mm adaptor
Manual adjust via thumb wheel
15% to 85% non-condensing operating humidity
Use of the probe on un-insulated conductors is limited to 300 Volt AC RMS or DC and frequencies below 1 Kilo Hz
Fluke SureGrip™ Current probe uses Hall Effect technology to measure AC/DC current. It is used with a oscilloscopes and other suitable recording instruments for precise non-intrusive current measurement. Output can be set to zero by manual adjusting the thumbwheel. Current probe has a inrush current rating of 600 Amps. It has a current rating of 30 Amps and 300 Amps AC or +/- 45 Amps and 450 Amps DC. It has an output sensitivity of 10 to 1 mV/A. Current probe comes with a resolution of +/- 50 to +/- 100 milli-Amps. It has a load impedance of greater than 10 kilo-Ohm and lesser than/equal to 100 pico-F.
Current probe has an conductor position sensitivity of +/- 1.5% relative to centre reading. It comes with a battery life of 30 hours. Current probe has a maximum conductor size of 19 mm diameter. It operates at a temperature rating of -10 to +50 deg C. Current probe operates at a humidity of 15 to 85%. It has a voltage rating of 300 VAC/DC. Current probe has a storage temperature rating of -20 to +85 deg C. It includes low battery indicator and cable of 2 m long. Current probe is limited to 300 VAC RMS and has a phase shift of less than 2 deg below 1 kilo-Hz. It has 9 V alkaline power supply. Current probe meets EMC standards.
|Application||The i310 current probe offered by Fluke can be used to measure both DC and AC current for accurate measurements|
|Catalog Description||Current probe is based on Hall Effect technology for use in measurement of both DC and AC current. May be used in conjunction with oscilloscopes and other suitable recording instruments for accurate non-intrusive current measurement.|
|Ships Ground. Eligible for expedited shipping||Yes|