Size: 80 mm Width x 71.5 mm Depth x 119.8 mm Height
Lokalbus: Inline data jumper connection, 500 KBPS/2 MBPS transmission speed; modbus/RTU: D-SUB-9 female connector connection, 1,2 - 115,2 KBPS, 9 positions
63 maximum number of supported devices
63 maximum number of local bus devices that can be connected
8 maximum number of devices with parameter channel
Input: polarity reversal suppressor diode, output: short-circuit and overload protection free running circuit
Load: 12 VA nominal inductive, 12 Watt nominal lamp and ohmic
Complete with I/O connectors
Phoenix Bus coupler features nine positions and operates at an ambient temperature of -25 to 60 deg C. Coupler works at power supply of 0.8 Amps DC and supply voltage range of 19.2 VDC - 30 VDC at three terminals. It has 0.5 Amps DC of power supply and 19.2 VDC - 30 VDC at another terminal. It offers 24 VDC of supply from main circuit to perform effectively and has I/O supply voltage of 24 VDC. Coupler supply 19.2 VDC - 30 VDC and consume 0.98 Amp for module electronics. It has communications power of 7.5 VDC with ± 5% of accuracy. It supports 63 devices per station and eight devices per parameter channel. Coupler comprises of 61 local bus devices including two devices on board I/O's.
Coupler is a eight-input, four-output digital device and has a durable two, three-wire spring-cage connection for convenience. Input circuit has a polarity reversal suppressor diode and output circuit. It has a free running circuit to avoid overload and short-circuit. It consumes 24 VDC and has a typical response time of approximately 500 micro-seconds. It has 15 VDC - 30 VDC input voltage range "1" signal and each channel consumes 3 milli-Amps of current. Coupler offers 24 VDC of output and 2 Amps of current per module. It features inductive nominal load of 12 VA and offers 500 Amps of current per channel. It has 12 Watts of lamp and ohmic nominal load. It operates under 95% humidity and 80 - 106 kPa of air pressure.
Coupler measures 80 mm x 71.5 mm x 119.8 mm. It features a lokal bus field bus system that has transmission speed of 500 kilo-bit/second or 2 mega-bit/second. It has a in-line local bus as designation and is connected using in-line data jumper. It also features modbus/RTU field bus system and has transmission speed of 500 kbit/second or 2 Mbit/second. It has modbus/RTU as designation and is connected using D-SUB-9 female connector. It also has supply designation and is connected using 8-position in-line connector. It is stored/transported at an ambient temperature of -45 to 85 deg C, 95% humidity and 70 kPa - 106 kPa of air pressure.
|Ships Ground. Eligible for expedited shipping||Yes|
|Degree Of Protection||IP20|
|Environmental Conditions||Storage Temperature: -45 to 85 deg C|
|Item||Modbus/RTU(ASCII) Bus Coupler|
|Size||80 mm Width x 71.5 mm Depth x 119.8 mm Height|
|Amperage Rating||0.98 Amp|
|Temperature Rating||-25 to 60 deg C|
|Standards||UL Listed, cULus Listed, LR, GL, BV, DNV, ABS, GL-SW, LR, GL, ATEX|
|Voltage Rating||24 Volt DC|